Gardner Denver 1000 Drill Rig & Package

Gardner-Denver 1000 Drill Rig
14W Drawworks
7-1/2" Rotary Table
Rated for drilling to 1000' ft
Dis-assembled for rebuild
Deck steel replaced in preparation for rebuild
Comes with all components necessary to rebuild back to original specs:
2-stage mast cylinder
3- large 8-1/2' outriggers
Piston style WX 1004 compressor (stored inside building)
Gardner-Denver FXG 5x6 mud pump (stored inside building)
24 ft 3-3/8" fluted kelly bar
Little Giant Swivel
Mayhew block for 1000 rig 12" single sheave
292 ft of 3-1/2" flush drill pipe
16 ft skid for set up for Gardner Denver 5x8 mud pump, Detroit 353 Diesel
Engine with Rockford clutch (1600 hours), with 150 gallon fuel tank
GMC 6-71 Power Unit with Rockford clutch, Rotary table slips, Blue Demon
Drag Bit 5, spools of cables, assorted bit breakers, 2" relief valve, pipe clamps and pick up heads, compression coupling and 4" valve, steel mud tank
2-3/8" IF to 3-1/2" Reg pipe to bit tubs, pipe spider rings, Rotary Table
Drill Up slips, shop built collars, T-Pipe for starter, cross over sub adapters, Tool holder for pipe in table, Petol chain wrenches, regular chain wrenches, Set of banded v-belts for mud pump skid, 2 rods for GD gear end, bull gear and eccentric, 2 pairs of sleeves for GD 5x8, valves caps for GD 5x6, cylinder head for GD 5x6, safe guard and Dodge gear boxes for mud pumps, pinion gear for GD 5x8 duplex 90%, new electric motors 1/2 HP - 3/4 HP - 1 HP stub shaft, power tower for Keystone Gardner Denver, miscellaneous bits
1973 Ford 8000 truck
Caterpillar 3116 diesel engine
10-speedRoadranger transmission
Located in Northern Region, USA